Heating POLYCLEAN drinker

Constant level polyethylene resin drinker.
Monobloc trough with slope for easy draining. Float valve is protected by a rotomolded double wall housing  right in the middle to create 2 different drinking trough spaces.

Fitted with :
- 1 float valve 42 l/min, 3/4" connection located under the drinking trough
- 1 float valve’s housing, removable without any tools
- 1 stainless steel water supply braided hose.
- 1 technical box at the back of the drinker, protected by a large hatch that can be removed without any tools.
- 1 high flow drain plug (Ø 90 mm) on the side for quick emptying.
- 4 ground anchoring points in the resin base.

It is essential to place the Polyclean on a minimum 20 cm concrete slab.

Fitted with:
- 2x80 W – 24 V heating units
Ideally located in the base for proper heating of the troughs and the water inlet during cold periods.
Caution : it is recommended to order the thermostat and the right transformer suitable for your facility and the number of heated drinkers.